ARIETE ATV QUAD GRIP 02620

Ariete 02620 is the Classic Ariete QUAD/ATV grip. Years of use have confirmed the value of this well-tried designs.

Anatomically profiled cut-out for thumb and forefinger
Outer flange pre-marked for piercing with a cutting guide for use with all-round hand guards
Palm in legendary Supersoft®, critical finger-grip area with half-waffle surface
Micro-pyramid pattern provides firm safe grip
Minimal inner flange
Two moulded safety wire-on grooves with space to tighten the wire
Slimline profile

…………………………………………………………………………………………………

The hypo-allergenic material used in the production of these grips, exclusive to ARIETE, was developed to get exceptional characteristics:

Details & Dimensions:

Sustainability	Sandro Mentasti Environmental Protection Program since 2007
Certifications	Quality Management system according to ISO 9001:2015 and Occupational Safety Management according to ISO 45001:2018
Lenght	125 mm
Material	Supersoft
Diameter	22 mm
Fitting instructions	1) After removing the old grips, clean the handlebar ends and the twist grip assembly with surgical spirit or contact lens cleaner or another solvent such as alcohol. 2) Clean and lubricate the inside of the grip with water or surgical spirit, and then push it into place on the bar end without twisting the grip. 3) Do not use soap, oil or petrol. 4) Wait 120 minutes before using the vehicle. 5) Before operating the vehicle, check that the throttle twist-grip moves freely. Fully open the throttle by turning the grip towards you, and then release it. The twist-grip should turn freely, and return to its normal closed-throttle position. If you have any problems or doubts, speak to a specialist mechanic, contact customercare@ariete.com, whatsApp +39 340 2326523 or telephone us on + 39 0332 310100 for advice.

You may also like…